*************************************************************************************************************************************************************************************************************************************************************************************************************************************************************************
澳大利亚插 定时开关 定时插座 定时器
1．将常通开关拨到下面，露出“圆圈&dquo;位置，此时定时功能开。
2．校对当前时刻。顺时针旋转刻度盘，让箭头指向当前时刻。
3．拨动插片设置程序。每个插片为15分钟，按到最下面时该段时间设置为接通。
4．把本定时器插入电源，表示定时器进入工作状态，再把用电器插头插入定时器插座，打开用电器开关即可。
- Tun the switch to“&dquo;to enable the timing function.
- Adjust cuent time,and then tun the dial clockwise to make the aowhead point at the position of cuent time.
- Set up timing pogam by pulling patches.Each of the patches indicates 15 minutes powe on o off. The time powes on when the patch stays outmost side.
- Plug in then the time is woking.Plug the electical appliance into the time and powe it on.
譬如：现在是早上8:00，您想让用电器在10:15~11:00工作，您就旋转刻度盘，让箭头指向8:00，再把10:15到11：00的三个插片按到最下面（如图示），用电器就能在那段时间内自动工作了。如果需要，您可以每天进行最多48段编程，让用电器在一天的不同时段自动运行。
如暂时不需要定时功能，可把常通开关拨到上面，露出“I&dquo;标志，此时定时功能关，电路处于常通状态。
The cuent time is 8:00 am,and you want the electical appliance to wok fom 10:15 am to 11:00 am.Fist,tun the dial clockwise to make the aowhead point at 9:00 am.Then pull out the thee patches between 10:15 am to 11:00 am to outmost position(see the pictue).The pled in electical appliances can wok fom 10:15 am to 11:00 am automatically.You can pogam the automatically.Tun the switch back to“I&dquo;to disable the timing function and powe on the time.
注意事项：Waning
※本品所接电器功率总和不得超过额定功率；
※本品断电后必须重新校队当前时刻；
※除非改变设置，否则每天保持一致的程序；
※请勿擅自拆卸定时器后盖。
※The total powe of the electical appliances connected the the time can not exceed the time&squo;s ated powe capability.
※Readjust cuent time if powe of the time tuns off.
※The timing pogam keeps unchanged unless setup changes.
※Do not dismantle the back cove fom the time.
